1.  This install is going to be a snap.

2. Let's get started.

3. Drill holes every 24” apart around pool as marked.

4. Use1/2” masonry bit.

5. Drill into concrete decking.

6. Holes need to be 1½” deep into concrete deck.

7. Use 1/2” anchor.

8. Insert anchor into deck, must be flush or below surface.

9. Take setting tool, place tapered end into anchor.

10. Using a sledge hammer lightly tap the setting tool one to two times to lock anchor into concrete.

11. Insert eye bolt into anchor.

12. Tighten eyebolt face open end away from pool.

13. Continue around pool.

14. Good, the hard part is done.

15. Start to unfold dome.

16. Make sure dome is unfolding as per drawing we sent you.

18. Continue to pull and unfold.

19. Position dome over pool.

21. Make sure doors are located as shown in drawing.

22. Cut a 1” to 1½” slice into pocket.

23. Expose cable in pocket.

24. Hook cable over eyebolt.

25. Continue around pool pulling slack out between eyebolts as you go.

26. This is how the eyebolts will look after dome is inflated.

27. Remove blower from box.

28. Position blower in a convenient location.

29. Insert blower under dome skirting.

30. Find the switch on the  blower.

31. Turn blower on high until the dome is completely inflated.

32. Lower the blower setting to lower setting.

33. Blower set on high.

34. Blower set low.

35. Come on in!

36. Fit blower to skirt.

37. Cut skirt so it will lay flat.

38. Now you have a tight fit.

39. Inside skirt should lay flat.

40. Cut corners so the skirt flap lays flat.

41. Don’t try this at home!

42. Congratulations, your dome is ready to enjoy.

43. Summer time. Remove eyebolts.

44. Insert stainless steel plug when the dome is removed.  This is done so debris will not get into the hole.